WINDFIX® MARINE+ is a PVAc based specially modified copolymer for marine plywood. It provides excellent adhesion to laminate/wood/veneer/particle board/block board to wood/ply/flush door/MDF/HDF. It also offers very high water-resistance and excellent bonding in lamination with all grades of wood after optimum curing. WINDFIX® MARINE+shows better and cohesive strength at elevated temperatures, a versatile balance that renders adhesive with very good heat resistance. It is formaldehyde free, non-flammable and non-combustible in nature.


In cold / hot press, bonding, laminate / acrylic / wood / veneer sheet to wood / ply / flush door / MDF / HDF.


  • The surfaces should be free from dust, oil, and grease. They should be dry and properly leveled.
    For best results, roughen the surfaces to be bonded.
  • Ensure the adhesive container is stirred well before use.
  • WINDFIX® MARINE+adhesive should be applied as a thin, even coating to one surface only.
  • Excellent flow and spray ability that can give higher coverage.
  • FOR PLY TO LAMINATE: Before allowing the adhesive to dry, bring both the surfaces in contact, align
    properly and start pressing from one side by using the wet squeezed cloth to avoid bubbles and
    ensure uniform contact.
  • FOR WOOD TO WOOD: Before allowing the adhesive to dry, bring both surfaces in contact and align
    properly. To get the best results to keep them pressed for 24 hours.
  • The excess adhesive that oozes out from edges should be wiped off with a wet squeezed cloth.
  • Pressure can be applied by using Clamps, Weight, Cold Press, Hot Press, Roller Press etc.
  • If required, pressure can be released after 3 to 4 hours and then bonded assembly can be
    processed further.


  • Excellent Water resistance and Heat resistance properties.
  • Ready to use and high bonding strength.
  • Higher coverage compared to a solvent-based adhesive system,42-45 sq. feet/kg.
  • Easy to apply by brush, spatula or glue roller. Low VOC, Green Product.


Appearance : Milky white emulsion
Solid Content : 44±2%
Viscosity at 30 C in cps : 30,000 to 60,000 cps
pH : 5.35
Gel time at 150 C : 60 to 180 Sec.
Density at 20 C : Approx 1.06 to 1.07 g/cm3
Solubility in water : > 1:20



Property Inspection Method Value
Minimum film forming a temperature DIN ISO 2115 0 C
Filler & pigment compatibility WCPL method Excellent
Tensile strength DIN EN ISO 527-3 Approx 6 ± 1N/mm2
Glass transition temperature WCPL method Approx 0 ± 2 C


WINDFIX® MARINE+ must be stored and maintained in the proper cool and dry storage condition. Iron or galvanized-iron equipment and containers are not recommended because the adhesive is slightly acidic.


If stored in the original, unopened containers at cool (below 30 C) and dry place WINDFIX® MARINE+ has a shelf life of 6 months from the date of manufacture.


1Kg, 2Kg, 5Kg, 10Kg, 20Kg, 50 Kg Carboy